Guide for bamboo 2nd gen AT change?

Hi there, 3 questions I hope somebody help me with, or can get me in the right direction.

First one, does anybody have a how to guide for the street to AT switch for the bamboo 2nd gen? I have seen content for GT and newer but not for 2nd gen. Toolkit doesn't fit on the beltcover so I think there're different steps for 2nd gen.

Second question, after riding today (bit wet asfalt) at some point I felt I couldn't make clean corners anymore, felt like the rear drifted away. When I place it on the ground it slowly moves to the left side, not a supposed straight line what could cause this and whats the advice to fix, take it apart and put it back togehter?

Last but not least I can't switch of my battery anymore, the light stays red and doesn't respond on the power switch any ideas / suggestions how to (hard) reset this, and could it be linked to other problems I described? thanks in advance.

Niels

 

I’ve got the same question (is there a guide for the street to AT switch for the bamboo 2nd gen?). Did you figure it out (what’s needed to make the switch)?

 

No manual so went to a local shop, they helped me replace them, so I can tell you they can fit From what I remember you have to remove the side protectors, and can't put them back on after placing the AT wheels. Also you need to reposition / loosing the belt engine to make the AT wheels fit.

 

Thx