evolve GTX is stuck in safe mode

If you can or when you get a chance get rid of the R2 remote and go back to LCD remote. I had the same problem and lots more but everything is back to normal no. I believe R2 remote controller is causing the problems but I can’t say for sure.

 

I own all three of the GT series and I haven’t had any problems with my boards. I Purchased the GTX March 26, 2018 it arrive April 2 everything was fine with the LCD remote the board just felt a little sluggish in Eco-mode. On the 16th of April my R2 remote controller arrived by the 21t that Saturday the R2 started vibrating constantly couldn’t cut off the board and stuck in Eco-mode. For a while everything went back to normal but then the board shut off completely now I couldn’t get it to come back on. Later that evening it came back on but was stuck in slow-mode so I took the opportunity and switch back to the LCD remote. Sunday morning I checked out my board it was like nothing had happened everything with work took it out all day long tried to get it to repeat itself but it works fine

 

I own all three of the GT series and I haven’t had any problems with my boards. I Purchased the GTX March 26, 2018 it arrive April 2 everything was fine with the LCD remote the board just felt a little sluggish in Eco-mode. On the 16th of April my R2 remote controller arrived by the 21t that Saturday the R2 started vibrating constantly couldn’t cut off the board and stuck in Eco-mode. For a while everything went back to normal but then the board shut off completely now I couldn’t get it to come back on. Later that evening it came back on but was stuck in slow-mode so I took the opportunity and switch back to the LCD remote. Sunday morning I checked out my board it was like nothing had happened everything was working took it out all day long tried to get it to repeat itself but it works fine.

 

Most likely one of the connections from one of the motors has been disconnected. Check both wires that connects to th esc.....wires rips out from hard riding time to time, just need to resolder the wires or replace it.

 

I just recalibrated the trigger value and then I could change from Safe to Fast.