AT setup, bushings as washers

Mods, can you change the title of the thread to read: "AT setup, bushings and washers"

Thanks!

----

Just getting to putting together my AT setup, installing the bearings, bushings and such. Found no instructions about putting the bearings and spacers together for the AT setup. After making this post I found the video where I have my solution. I also didn't know that the AT drive hub pulls off from the wheel. So now things make better sense on how they go together. I presume we follow the same washer spacing as the street setup.

 

Thanks Andy. So with the newer ones just use and stick to the same washer/spacer setup as what you took off when the board was new. A good thing is to record or take a picture of your board the first time you switch / swap your wheels out.