Trampaboards post I made.

Ted from trampa told me he would make Huds to fit Evolve GT board and backed out. Just like he Did when Evolve asked him. According to what he told me. DON'T ORDER FROM HIM they will not fit and he will not do anything other than be a jerk. I tried to tell him that a lot of the evolved will want his dope ass hubs and 9" At's but he was still a jerk. I did everything I could and now I just have anger inside because his tiers and hub are better than anything Evolve has.

 

I have been checking out there hubs and would love to have a set or two. To bad he doesn't want to make any for the Evolve crew.

 

Why oh why do they not fit??? Is it the bearing size? hub size?

 

Both, according to the guy that makes them.

 

I bought a set before I knew there were issues and what doesn't match (as far as All Terrain goes) is the bolt pattern for the drive gear. So I have three Trampa and one regular hub on my Carbon Gen 2 AT. Oh I also had to add a couple extra washers on the axels because the Trampa hubs are more narrow and you run out of thread to tighten the wheel, adding two washers worked. It is not the greatest fix but looks cool from one side.

 

Does it ride well that way? I have lots of washers from Evolve and would love to pimp my board but, I gave up on that months ago. You give me some hope! Is Gen 2 different than GT with the truck spec's?

 

*EDIT* The following may be entirely wrong:

Gen2 AT and GT trucks are different diameters. The GT is built to use the same trucks for street and AT, so it uses a smaller axle diameter (I think it's ~7.9mm). The Gen2 AT axle uses a 9.5mm inside diameter bearing.

 

If someone wants to sponsor me a GT, I'll figure out what it takes to make that swap work too but, for now, here's my setup on my Gen2 board if it helps anyone out:

Trampa parts on Evolve Gen2 trucks