R2 Hard Reset ?!!

Hi ,
i post this thread cause my bamboo GTX makes me crazy ...
during my last ride , the R2 remote just dropped the bluetooth connection of my board , and there was no fu..g way to pair it back

i tried everything , power up board first , Remote first , remote searching mode ( 2 sec one the first button) , recharge R2 at maximum . even re-initialise the throttle configuration

the worst part is : my old R1 is actually pairing well but i hate it !

is there a way to hard reset the R2 remote ? or maybe Reset the pairing buffer inside the board ?

Dunno what to do here
thanks a lot for your help
Cya

 

Flagadajones,

Not sure if this will help or not but have you checked the protocol just in case it somehow got switched? Here is a link that may be helpful for checking. I think there may also be a video on this somewhere too but at least this is a start.
Hidden remote menu: Protocol V1/V2

Take Care

 

... YOU .....
.... SIR .....
Are my HERO !
it's exactly the mistake i did trying to reset the trottle values and went into the wrong menu

THANK YOU SO MUCH
CHEERS

 

Anytime, I am glad that was the issue and you can ride again. Enjoy and Skate on! ;-)

 

I can't get my board out of safe mode. I was skating along I stopped at a set of lights went to take off and board wouldn't go I was in gt mode. i turned board and remote off then back on been stuck in safe mode since how would I fix this?

 

Open the board, remove the battery check and clean all connections and reassemble.
I needed to resolder a couple of wires/connectors a few weeks after buying it because whey got loose somehow.

Be prepared, the battery does sometimes try to bite you when connecting it to the controller.. if it happens don't be too scared.