200kv motor test

FYI FYI: 200Kv motor info

In short, running 200KV motors at higher speeds eventually will melt the ESC

 

Doesn't really want me to risk it after reading this...

 

So my take after reading/observing, if one of the motors seized up or show any sign of degrading performance. Immediately stop using the board and replace the motor or it will short/melt the ESC. Also, avoid overheating the motors by not going through tall grass or conditions that put a heavy load through the motor.

It's also hard to tell what condition the motors were put through with all of the issues I've read so far. Do you ride it in the rain, wet condition, thick grass for a long duration, dirt road, do you clean the motors etc...

I still plan on switching to the 200KV on my CGT 8" A/T this summer.

 

Can anyone plz tell me if I have a motor problem or otherwise?

During hill stress one motor always stops working. I can turn off the board and wait 30 seconds or so and turn on again and works till any stress comes on again. Then it repeats. I'm about to switch the motorleft to right right to left along with all connections to confirm its the motor or something else. Anyone have this same problem or advice? Thanks!

 

What board do you have and what's your weight? The motor controller or motor might be overheating under load.

 

Hi thx for answering and asking.

Carbon GT. 190lbs

 

SO will 200kv motors on a evolve board burn out the wax?